How to convert to Mesh for using in Geco??

Hi,

I'm pretty new in GH, Actually I made a geometry by lofting in GH, then I want to use Geco to link with Ecotect. So I do need a Mesh to use "Export Mesh to Ecotect" toggle, but I don't have any mesh, it is just a lofted surface. how can I convert my loft to Mesh to use that toogle?

p.s.: I attached my Rhino and GH files.

Thanks a lot for your helping.

Attachments:

1.3dm, 26 KB
1.ghx, 107 KB

Replies to This Discussion

Permalink Reply by Luis Fraguada on March 15, 2011 at 5:07pm

Look under the mesh tab...there are two methods that I can think of off the top of my head, mesh surface and mesh brep. If you have a single surface, then mesh surface might be your best bet....here you can control the u/v subdivision of the mesh. If you have a polysurface, I would explode it into surfaces and use the mesh surface on each resulting surface. If the geometry is too complicated, then use Mesh Brep with the custom mesh settings and control the Max Edge Length. Remember, the more subdivisions you have, the more calculation time in ecotect.

RSS