Grasshopper

algorithmic modeling for Rhino

how to build a surface from points in version 0.9.0012?

Hi all!

I want to build a surface from points but by applying the cross-reference between the data I only get the edge, the image shows the pattern I use in grasshopper (attach conoidedeplucker.gh file)

in previous versions only had to choose between the options to click on the component fn.

as can be seen CrossRef add the component for which you previously obtained with single click.

Please if anyone can help

conoidedeplucker.gh

Views: 1138

Replies to This Discussion

Permalink Reply by Michael Pryor on September 21, 2012 at 4:20pm

zoom to the cross reference, add a new input to have abc. only use one cross ref. one eval in each input. then plug output a to input x, output b to input y, output c to input z

Permalink Reply by Lucybell on September 21, 2012 at 5:22pm

Hi Michael

Thanks for the reply.
but plucker surface rises as compared with old component is generated (n +1) * (n +1) vectors in space, whereas CrossRef generates (n +1) * (n +1) * (n +1) vectors in space, therefore does not raise the surface correctly

Permalink Reply by Andrew Heumann on September 21, 2012 at 6:04pm

You were close, but the order of components was wrong. 

Permalink Reply by Lucybell on September 21, 2012 at 6:20pm

Oh! my good!

Thank you very much

 

Permalink Reply by Michael Pryor on September 21, 2012 at 6:21pm
guess thats what happens when you reply without using grasshopper :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service