Grasshopper

algorithmic modeling for Rhino

grid from curves?

Hi!

I want to cull a grid based on several curves, so that the grid follows these curves (the curves will be paths and the grid paving stones).

My idea is to create a grid from the curves for the paths (this are already horizontal and vertical lines producing a grid, maybe I can use the intersection points for a new grid) so that the cells can be containmant curves. Is that possible?

thanks, B

Views: 1104

Replies to This Discussion

Permalink Reply by Yasser Hafizs on May 29, 2013 at 11:30pm

Project component will work for that, also make a surface first from your path curves as target surface you want to project.

Permalink Reply by AB on May 30, 2013 at 8:27am

If I understand your question, this discussion may be the direction you need to look...

http://www.grasshopper3d.com/forum/topics/closed-curves-cells-from-...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service