Grasshopper

algorithmic modeling for Rhino

Failing to create solid brep

Hello,

I am trying to calculate the volume for the brep generated in my definition. I was able to join surfaces and cap holes, but it still leaves me with an open brep, from which I am unable to use a volume component. I am stumped. 

Does anybody have any suggestions? Or is my logic screwed up to begin with?

Thanks for the help!

-Dan

Views: 3296

Attachments:

Replies to This Discussion

Permalink Reply by Michael Pryor on July 22, 2012 at 9:54pm

If you bake it you will see cap is only giving you the bottom closure not the top. Cap is not sufficient enough to find the enclosure of those curves. I suggest lofting or sweeping that top, then joining that as well.  

Permalink Reply by Dan Raznick on July 23, 2012 at 12:42am

Thanks! I didn't even realize it was doing that! I just lofted the two top curves, like you said, and added the surface to the join. Closed brep achieved.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service