Grasshopper

algorithmic modeling for Rhino

Facade Pattern

Hi,

I am new to grasshopper. Can some one help me with the result show in attached picture.

I used lunchbox to get the pattern, but how can I get that slight movement in the pattern as shown. I don not know how to work with spirals.

 

 

 

 

 

 

 

 

 

 

 

 

 

Image Courtesy: Google Image

Views: 2023

Replies to This Discussion

Permalink Reply by Michael Pryor on January 6, 2013 at 10:15am
Permalink Reply by djordje on January 6, 2013 at 10:43am

Try this:

Attachments:
Permalink Reply by Artyom Maxim on January 6, 2013 at 11:03am

Hi, 

this is very easy, you just need to remap all the points of your diagrid, or any other subdivision by height, and then rotate them around the center axis.

The convenience here is that you can use any subdivision grids, including the ones from lunchbox.

Attachments:
Permalink Reply by Felipe Romero on January 7, 2013 at 11:41pm
Permalink Reply by Tushar Sharma on February 18, 2013 at 7:39am

Artyom,

I am doing something similar, but cant get the remapped points on the upper circle. In my case the circle diameters are different i.e a cone.

 

Regards,

Tushar

Permalink Reply by Artyom Maxim on February 18, 2013 at 12:02pm

Hi,

do you have a .gh file?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service