Dynamic Louver_Honeybee_Window Shade Generator

Hi everyone,

I am tying to analyse the effect of external dynamic louvers/blinds on the thermal loads in the building using honeybee components Window shade generator and Energy Shade Benefit Evaluator. I want the shade/blind to be ON, if there is high solar radiation falling on the window. I had set the control type and set point in this case to 1 and 300 W/m2 respectively to generate the results. But, when I change the control type or setpoint input, no change can be observed in the result. Is there something to do with the input in the shadeSchedule_? I had left it default ALWAYS ON in all the cases. Is there any other piece of information I may be missing?

Also, is it possible to change the angle of the louvers depending on the control type, rather than just switching ON and OFF the shading? Can someone help?

Thanks,
Meha