Grasshopper

algorithmic modeling for Rhino

developing Regular diamond grid

Dear Community

I used kangaroo for formfinding the basic geometry for a design.

Now I want to develop a diamand shaped gridstructure and panalize the surface. 


In order to do so I converted the surface from meshes to a polysurface trough T-spline.

Afterwords I subdived the individual surfaces and created a curve trough the diagonal points in two directons.

The problems is that the grid is irragular. This is because the surfaces are different.

Is there a way to achieve a regular diamond grid?

I attached the grasshopper definition and the rhino file. 

Views: 1195

Attachments:

Replies to This Discussion

Permalink Reply by Yasser Hassan on January 22, 2014 at 10:16am

Something like this.

Thanks in advance

Permalink Reply by Hannes Löschke on January 22, 2014 at 12:19pm

How is this regular?

Permalink Reply by Yasser Hassan on January 22, 2014 at 1:26pm

well there goes my reference. 


Thank you for pointing that out.

Permalink Reply by Daniel Piker on January 22, 2014 at 10:18am

I'll take a closer look later, but perhaps the diagonalize component I describe here could be useful

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service