Grasshopper

algorithmic modeling for Rhino

DATA STRUCTURES and loft problem ,,HELP !!

hi GUYS,, I made a surface and extracted isocurves from it then i wanted to add a code for surface ribbons which divide the curves into lines and the rotating it by some attractor then ,,lofting it again ,,

But THE PROBLEM WITH ME

is that i want each curve from the isocurves to loft separately which doesn't happen it begin to loft all the cyrves together ,, i know it may be an easy problem but am new here and i really need help urgently in my project.

THANKS in advance 

Views: 1444

Attachments:

Replies to This Discussion

Permalink Reply by karim on June 14, 2013 at 11:15am

thanks michael for your help ,, can you show it on the code i attached because am still failing in doing it

Permalink Reply by karim on June 13, 2013 at 9:18pm

where do I use the shift lists ??

Permalink Reply by karim on June 14, 2013 at 11:17am

the code with shift list

Attachments:
Permalink Reply by karim on June 14, 2013 at 11:19am

re-uploading the 3dm file 

Attachments:
Permalink Reply by Michael Pryor on June 14, 2013 at 12:06pm

not really sure what your trying to do, or the goal of this. Can you explain?

Permalink Reply by karim on June 14, 2013 at 12:32pm

I was trying to do something like this by extracting the isocurves and applying that code for it but when i did that it lofts all the curves 

Attachments:
Permalink Reply by karim on June 18, 2013 at 4:24am

Hi Michael ,, I hope u figured out whats the problem with my code 

Permalink Reply by Michael Pryor on June 14, 2013 at 12:07pm
Permalink Reply by karim on June 14, 2013 at 12:56pm

It's a good one I tried it but it's not giving the exact shape of louvers 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service