Grasshopper

algorithmic modeling for Rhino

curve domains

Is there a quick way to rebuild a curve's domain to T-value so that not matter the curve the domain will always range from 0 to 1. i.e. 0.5 being the midpt?

I have a script from Peter Van Hage http://www.arcnarc.com/?p=71 that does this but I would think this is a common problem...

Views: 2081

Replies to This Discussion

Permalink Reply by Luis Fraguada on July 14, 2009 at 6:28am
Hey Bruce, check out the curve param component...right click in the center and check 'reparemeterize.' This also works with the surface param component (u and v will be reparameterized to 0-1)
luis
Permalink Reply by Bruce Davison on July 14, 2009 at 7:55am
Thanks Luis... found it right after my post!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service