Grasshopper

algorithmic modeling for Rhino

_CreateSolid in Grasshopper

Hi, can't find this in Grasshopper, I know of the solid union, that command doesn't work. What I'm trying to do is to create a solid from 4 surfaces. The _CreateSolid command in Rhino works but not the grasshopper solid union command.

Anything I'm dooing wrong? Do I need to trim/untrim surfaces before joining them?

And sorry for a basic question like this (I assume it is since I can't find another thread about it in a glance).

Views: 193

Replies to This Discussion

Permalink Reply by Luis Fraguada on July 6, 2010 at 2:53pm
_CreateSolid is not exposed in the .Net or RhinoCommon SDKs therefore we cannot access them in a GH component. I have put in a request for this, hopefully it will show up in the next service release or update.

Luis

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service