algorithmic modeling for Rhino

I use this component to exract control points of a surface..

I am trying to move some of these points to deform the surface but no luck.

Should I assume that this comp just gives these point as a copy with no control over the geometry ?

How can I deform a surface from its control points in GH

Thanks a lot Pantelis

Views: 778

Reply to This

Replies to This Discussion

Hi Pantelis,

Yes, you are right - once control points are extracted they need to be "imported" again so to say, in order to control the shape of the model. You can do this by interpolating the curves from those points, and then lofting those curves. Or directly making the surface from those points. Check these two methods in the attached files.


THANX A LOT !!!!!!!!

very craetive , thanx again






  • Add Photos
  • View All

© 2020   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service