Grasshopper

algorithmic modeling for Rhino

center point of cylinder

Dear All,

I have been trying to find the center point of the top of this cylinder for a while but not having much success. I think I'm meant to be using the Evaluate Surface but I'm not getting anywhere - could someone point me in the right direction?! many thanks!

Views: 2053

Attachments:

Replies to This Discussion

Permalink Reply by Chris Tietjen on February 21, 2013 at 5:41am

Ignore the red warning or if you don't want to see it cull out the line like curve in the previous component.

Permalink Reply by MARIO VERGARA on February 21, 2013 at 5:42am

see image attached

Attachments:
Permalink Reply by Dedackelzucht on February 21, 2013 at 5:48am

hihi and an other one :-)

Permalink Reply by Tash Tash on February 22, 2013 at 8:48am

All work a dream - many thanks for your super-fast responses!

Permalink Reply by Michael Pryor on February 22, 2013 at 9:49am

and yet another. This will choose the top no matter what orientation the cylinder is drawn the highest end is picked like Dedackel's

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service