Grasshopper

algorithmic modeling for Rhino

Catenary loft giving brep as outcome

Hey guys,

Any way I can get a surface as an output from lofting Catenary curves ? or if there is a way I can subdivide the brep output into points and re-structure the surface again as a surface ?

here is the outcome I am trying to manipulate

Views: 343

Attachments:

Replies to This Discussion

Permalink Reply by nikos tzar on February 1, 2015 at 6:40am

Hello Mohanned,

It seems that if you change the polylines into curves you get a single surface:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service