Grasshopper

algorithmic modeling for Rhino

Capping (3 edge surfaces) out of a triangular network of lines

Hi everybody,

I made a short GH definition to get 3 edge surfaces out of a triangular network of lines.

My problem is that I don't know how to automatically iterate the process to get 100% of surfaces at the same time.

Any suggestions?

 

THANK YOU !!!

 

Matteo C.

 

 

by the way:

I know that sometimes my definition produces duplicate surfaces, but cleaning after baking into Rhino isn't a trouble.

Views: 1242

Attachments:

Replies to This Discussion

Permalink Reply by Yoann Mescam (Systemiq) on June 13, 2012 at 11:05am

Here is my try at it.

Attachments:
Permalink Reply by Matteo Cherubini on June 14, 2012 at 12:42am

Dear Danny, dear Systemiq,

thanks a lot for your proposals, guys.

Both of them aren't perfect...but still VERY interesting!

Mine is far from being perfect too.....

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service