Grasshopper

algorithmic modeling for Rhino

can't find the right component for stretching an object/ change a radius location

nur.pdf

I need the object to change from A to B (see pdf attached)

the idea is to stretch the bottom part of the pipe while the upper part, the edges, shortens by the same distance, that way the overall length of the pipe stays the same. another way of putting it- move the location of the radius along the pipe.

I'm new with Gh, therefore I've tried using the basic components I know. would love to use some more complicated ones if needed.

Thanks

Views: 387

Replies to This Discussion

Permalink Reply by Hannes Löschke on December 5, 2014 at 7:35am

So what have you got so far?

Permalink Reply by Hyungsoo Kim on December 7, 2014 at 7:51pm

Is it too late to reply? You may have found the answer already. See once, if you want to.

Attachments:
Permalink Reply by nur saar on December 8, 2014 at 10:01am

never too late :)
thanks a lot!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service