Array of Brep

Hi there,
I need help from Grasshopper community

Is there any way to array a Brep?

Replies to This Discussion

Permalink Reply by Luis Fraguada on August 8, 2009 at 1:37pm

Short answer: probably.
Long answer: be more specific. Prob a series+vector+move will do you right.

Permalink Reply by Stephan on August 8, 2009 at 2:46pm

Ok I ve made a BiArc which I have 90° rotated and mirrored. Thus I can sweep on 1 rail to obtain a Brep. After a boolean difference between this Brep and a cap holes cylinder I ve obtained a new Brep :

Firstly I want to union the initial Brep with its twin mirrored
Secondly I wish to array this Brep in order to make a Pattern.

What I want to achieve it's to create a "connected holes pattern"

Herewith attached a ghx file to understand what I want to do

Thanks for your help

Attachments:

connected holes.ghx, 171 KB

Permalink Reply by Lars Renklint on August 8, 2009 at 5:23pm

Here's one way of doing it. From the definition that I posted here - http://grasshopper3d.ning.com/profiles/blogs/connected-holes I've simply copied the last bit of the definition and connected it to yours.

Attachments: