David Rutten's Discussions (13,838)

View

Discussions Replied To (13597)	Replies	Latest Activity
"The attached code adds or removes parameters from a component menu. I didn't set a…" David Rutten replied Jul 29, 2014 to Add/remove component parameters depending on zoom level dynamically	8	Jul 29, 2014 Reply by Daniel Gebreiter
"It would be fairly trivial to make the component 'unfold'. You'd still have to overr…" David Rutten replied Jul 29, 2014 to Add/remove component parameters depending on zoom level dynamically	8	Jul 29, 2014 Reply by Daniel Gebreiter
"Although you can override the display as much as you like, you probably shouldn't be…" David Rutten replied Jul 29, 2014 to Add/remove component parameters depending on zoom level dynamically	8	Jul 29, 2014 Reply by Daniel Gebreiter
"How do you specify the location? -- David Rutten david@mcneel.com" David Rutten replied Jul 29, 2014 to trimming curves at determined lengths	6	Jul 29, 2014 Reply by David Rutten
"The morph from straight box to twisted box is easy, because I can figure out 'where'…" David Rutten replied Jul 29, 2014 to advanced box morph	13	Jul 30, 2014 Reply by kipodi
"If you propose an algorithm of how to map a 3D point (xyz) into twisted box (uvw) co…" David Rutten replied Jul 29, 2014 to advanced box morph	13	Jul 30, 2014 Reply by kipodi
"Hi Peter, I think you've put your finger on the hardest problem of all in GH ideolo…" David Rutten replied Jul 29, 2014 to Pain Points in Grasshopper	266	Oct 8, 2017 Reply by Martin Siegrist
"Not at the moment. There is no morph logic from twisted boxes, only to twisted boxes." David Rutten replied Jul 29, 2014 to advanced box morph	13	Jul 30, 2014 Reply by kipodi
"Are these points defined in a file, where each line looks like your example?" David Rutten replied Jul 29, 2014 to Tricky1 - Latitude & longitudinal co-ordinate points into points & lines	7	Jul 30, 2014 Reply by Danny Boyes
"Then you need to make sure that your command doesn't return befire your window is fi…" David Rutten replied Jul 28, 2014 to RhinoScript Flow Control	7	Jul 28, 2014 Reply by David Rutten