Hannes Löschke's Discussions (1,185)

View

Discussions Replied To (1159)	Replies	Latest Activity
"Lists with different paths don't combine. Use the simplify option on the Crv Params…" Hannes Löschke replied Dec 16, 2013 to loft a group of curves problem	2	Dec 16, 2013 Reply by karim
"There are a few components around, that help you manipulate the Rhino viewport. Hors…" Hannes Löschke replied Dec 16, 2013 to Viewport	5	Dec 16, 2013 Reply by Henne
"Doesn't look like it's crashing. Creating 2500 Surfaces just takes some time. Trim…" Hannes Löschke replied Dec 14, 2013 to Crashing - Split surface - Trim solid	2	Dec 17, 2013 Reply by o.s
"Without knowing too much about machines and stuff, you should take your hands off mi…" Hannes Löschke replied Dec 13, 2013 to Machining/milling time; cnc; routing	8	Dec 17, 2013 Reply by Marcus Strube
"So as an approximate answer: 3hours... Seriously, it all depends. Say, you have a s…" Hannes Löschke replied Dec 12, 2013 to Machining/milling time; cnc; routing	8	Dec 17, 2013 Reply by Marcus Strube
"Both sets need to be lists at the same branching level on order to get what you want…" Hannes Löschke replied Dec 12, 2013 to Solid Difference Two Lists	1	Dec 12, 2013 Reply by Hannes Löschke
"Depends on your mill, the complexity of your object, your tool and finally the way,…" Hannes Löschke replied Dec 12, 2013 to Machining/milling time; cnc; routing	8	Dec 17, 2013 Reply by Marcus Strube
"can't see where this would happen..." Hannes Löschke replied Dec 12, 2013 to List Management - Shift List - Loft	5	Dec 12, 2013 Reply by Hannes Löschke
"if you switch the loft to "straight" in the loft options, you will essentially get a…" Hannes Löschke replied Dec 12, 2013 to List Management - Shift List - Loft	5	Dec 12, 2013 Reply by Hannes Löschke
""Geometry" is the most general representation of anything, that could be described a…" Hannes Löschke replied Dec 11, 2013 to Problem with "rotate" and "point on curve" command	12	Dec 11, 2013 Reply by Slavke Stevko