algorithmic modeling for Rhino

Forum Discussions (33,607)

Sort by: View

Discussions	Replies	Latest Activity
How do you find the curve parameter (t) from a point on a curve? Hey! Is there a component that allows you to get what the curve parameter (t) is by inputting the curve and the point you want the parame… Started by McKinnley Workman in Discussion	3	Oct 20, 2011 Reply by McKinnley Workman
pan and zoom don't work Hi, I've just baken some geometry from grasshopper into rhino, but when I'm trying to pan in rhino or zoom, it doesn't work, while orbitt… Started by Goossens Niels in Discussion	2	Oct 20, 2011 Reply by Goossens Niels
[again!] System req. for Grasshopper - 16gb vs iCore 2.30 The issue goes like this - I'm going to buy one of the Lenovo's laptop from W520 series. The prices for those two config. below are almost… Started by Przemyslaw Kolodziej in Discussion	1	Oct 20, 2011 Reply by Danny Boyes
get upper surface off box Hi, I need to have the upper surface off a box I've created in grasshopper, what command should I use? Thanks Started by Goossens Niels in Discussion	4	Oct 20, 2011 Reply by Goossens Niels
Hover info Hi, when I used to hover above an icon or in-and outputs, some info came up, so I knew what every icon stood for or what the values were of… Started by Goossens Niels in Discussion	4	Oct 20, 2011 Reply by Fredrik Skåtar
Trim permanently Hi I have a trimmed surface i bring into Grasshopper via. the surface component. I am only interested in the trimmed surface, but when i us… Started by Thomas Bildsøe in Discussion	2	Oct 20, 2011 Reply by Clayton Williams
Repeat Random Operation? Hi, I'm working on generating random tubes inside a geometry. I managed to draw a spline through random points inside a sphere. Is it pos… Started by Jooro in Discussion	5	Oct 20, 2011 Reply by Jooro
triangular mesh on bubble surface first getting a bubble surface by deforming a sphere (thats the funny part), I´ll manage that! Distributing points over that (closed) surf… Started by ANGELOS in Discussion	1	Oct 20, 2011 Reply by Mateusz Zwierzycki
can't morph surface Hi, I've created a surface and now I want to morph some things on it, but I can't divide the surface, so I can't create morph boxes... I've… Started by Goossens Niels in Discussion	2	Oct 20, 2011 Reply by Goossens Niels
Looking for help with writing a definition I'm currently working on a theory project on teleportation as a means of travel. Rhino with Tsplines was used for freeform modeling. I woul… Started by shaun in Discussion	6	Oct 20, 2011 Reply by Yoann Mescam (Systemiq)