algorithmic modeling for Rhino
Trim permanently
Hi
I have a trimmed surface i bring into Grasshopper via. the surface component. I am only interested in the trimmed surface, but when i use for example the dimensions component, it registers the untrimmed surface, and ie. surface divide also works on the trimmed surface. Is there anyway to trim it permanently?
Kind regards
Thomas
I have a trimmed surface i bring into Grasshopper via. the surface component. I am only interested in the trimmed surface, but when i use for example the dimensions component, it registers the untrimmed surface, and ie. surface divide also works on the trimmed surface. Is there anyway to trim it permanently?
Kind regards
Thomas
Views: 428
Replies to This Discussion
-
Permalink Reply by Thomas Bildsøe on
-
I found a solution. I created a C# component, which uses the Brep.Shrinksurface function.
/Thomas -
-
Permalink Reply by Clayton Williams on
-
Hey Thomas,
I'm trying to do this right now, but am not very familiar with C#. Any Suggestions? or could I take a look at your component?
Thanks,
-Clayton
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
© 2024 Created by Scott Davidson.
Powered by
