algorithmic modeling for Rhino

Forum Discussions (33,608)

Sort by: View

Discussions	Replies	Latest Activity
attractor point with curves hello , In my urban project , i didn't succeeded to apply an attroctor point script to curves , if someone please can help me to do it . … Started by Omar in Discussion	6	May 1, 2013 Reply by Omar
Kangaroo to recreate Ned Kahn's Project Hi everyone, I'm very new to Grasshopper and Kangaroo. And, I've used one of user's definition to recreate one of Ned Kahn's wind project.… Started by Jim in Discussion	0	May 1, 2013
Random component turning out not so random results I am attempting to construct a paneling definition similar to Lunchbox's 'Random Quad Panels' component. I am using a random component to g… Started by Danila Babko-Malyi in Discussion	2	May 1, 2013 Reply by Danila Babko-Malyi
Hexagon as Box Hi I need some help in arrange a Geometry on an hexagonal grid on an single surface. Is it possible to make a box with more or less edges t… Started by Andreas Schiffer in Discussion	10	May 1, 2013 Reply by alex jenter
Perforated Mesh relaxation Help!! Hi i need some urgent help with regards to making a Pre-perforated mesh box with four sides all of which have perforations on them. Then re… Started by Aaron Hills in Discussion	0	May 1, 2013
Index Can I get something like this to be seen in Rhino with the help of Grasshopper OR with the help of Rhino OR with the help of BOTH?! :D Can… Started by Ahmed Hossam in Discussion	31	May 1, 2013 Reply by Ahmed Hossam
Paneling ! Hi All I am New To Grasshopper I Want To Know How To Get Something Like This (00.jpg )I Got Some Thing Like In ( 1) And Want to konw How t… Started by Reda Dragon in Discussion	4	May 1, 2013 Reply by Reda Dragon
About giving a colour to a closed curve (for example) circle It's not like I'm just asking you to give me an answer ... I read in GH Primer on page 61, but it seems too complicated and much more than… Started by Ahmed Hossam in Discussion	5	May 1, 2013 Reply by Ahmed Hossam
Tesselated Cell Help! Hi, Would anyone know how to generate the pattern below on a surface?I've spent the past week trying to figure it out but can't get anythin… Started by Tiffany Lee in Discussion	7	Apr 30, 2013 Reply by Chris Tietjen
is it possible to trim a surface with two others? i would like to trim the green surface with the black and red surfaces the green surface is in grasshopper and the others are in rhino Started by Freeland in Discussion	2	Apr 30, 2013 Reply by Freeland