algorithmic modeling for Rhino

Forum Discussions (33,608)

Sort by: View

Discussions	Replies	Latest Activity
Good Grad Schools? I am planning to go to grad school to get Master of Science in Architecture with an emphasis in computational design methods. I have a Bac… Started by Stan Carroll in Discussion	38	Dec 16, 2013 Reply by Aaron M. Ryan
Nurbs control polygon edit with fixed curve length and start end points I have been looking into drawing a curve with fixed endpoints and a specified length where you can edit the control polygon. I've not see… Started by thom simmons in Discussion	4	Dec 16, 2013 Reply by thom simmons
Problem with offsett on Facet Lamp Hello guys,I have a problem: I'm doing a lamp with facet splitted surface.When I have to do the offset to put a little separation between t… Started by Marco Paffi in Discussion	0	Dec 16, 2013
can't rename 'A' or 'B' param on Addition component Hello, If I right clic the A or B param of the addition component, I can't rename it while it's possible with multiplication, division and… Started by Sylvain Usai in Errors, Bugs and Oversights	5	Dec 16, 2013 Reply by Mateusz Zwierzycki
cluster / user object missing icons Hi, If I create a cluster or user object and I'm looking at "show icon library ...", there are not all icons of Grasshopper (e.g.: Surface… Started by Simon Schiefer in Errors, Bugs and Oversights	6	Dec 16, 2013 Reply by horst Becker
metaballs to geometry Does anyone know how to convert a series of meatball curves into a clean piece of geometry? I have tried lofting continuous runs and then… Started by Sam Florance in Discussion	3	Dec 16, 2013 Reply by martyn hogg
What are some of the best institutes to pursue a PhD in computational/parametric/generative design? The institute could be a research lab or a university. Started by Chintan Pathak in Discussion	1	Dec 16, 2013 Reply by djordje
Interface suggestion - Obsessive labeling I've gotten into the habit of grouping individual components in order to use the group name to label the components. I wonder is it possibl… Started by Chris Wilkins in Discussion	40	Dec 16, 2013 Reply by Victor Leung
slider & lines Can I use the slider to select the specified geometric lines? Regards Alex Started by Alex in Discussion	5	Dec 16, 2013 Reply by Alex
loft a group of curves problem can anyone tell why these curves doesnt loft normally ? Started by karim in Discussion	2	Dec 16, 2013 Reply by karim