algorithmic modeling for Rhino

Forum Discussions (33,608)

Sort by: View

Discussions	Replies	Latest Activity
New curve from attractor's pick of closest point Hello everyone me trying attractor points. I'm trying to create a new curve from existed curves' data. My rule is - pick the closest point… Started by Oytun Gür in Discussion	2	Dec 13, 2014 Reply by Oytun Gür
Surface from 2D Crvs to 3D with same area on the top you see a flat piece of paper which than will be cut on the edges and folded/bended into form to achieve a 3dimensional constr… Started by Judith Wid in Discussion	2	Dec 13, 2014 Reply by Judith Wid
Smoothed ribs on mesh surface hello,I'm trying to create a rib on a mesh surface following an input curve.I've already test with "pull to curve" of Kangaroo, and then (t… Started by Andrea Mercurio in Discussion	2	Dec 12, 2014 Reply by Andrea Mercurio
Rhino command GrasshopperOpen - not working? I was searching a way for automatically opening a GH file associated with the current Rhino file (has the same name and position) and I dis… Started by Marco Traverso in Errors, Bugs and Oversights	2	Dec 12, 2014 Reply by Marco Traverso
Perforation on Surface - how to randomize perforations and alter shapes Hello, I am new to Grasshopper and the Grasshopper3D forum. I have been doing a lot of research on here and am looking forward to learning… Started by AdnFrs in Discussion	0	Dec 12, 2014
Issues with Weld Mesh Vertices I am getting a few interior vertices that are not welding despite being coincident, overall everything is behaving very nicely accept for a… Started by Moonbeast in Discussion	1	Dec 12, 2014 Reply by ng5 Alex
Can`t use Weaverbird Hi...I just download weaverbird... and install it... look normal... but when I try to use it ... it turns red and mark an error "File not f… Started by Ana Ruiz in Errors, Bugs and Oversights	1	Dec 12, 2014 Reply by ng5 Alex
Dynamically adding unique MD slider values to a list I'm stuck. I'm trying to generate a dynamic list that adds MD slider values to the list as the MD values are altered. Any ideas? Maybe with… Started by Anton Bakker in Discussion	2	Dec 12, 2014 Reply by Anton Bakker
loft 2 grids,clipper,problem hi all... i'm trying to offset these grid (with clipper plugin )and loft them, but i can't do this... if anyone can help... thanks... Started by Esmaeil Mottaghi in Discussion	19	Dec 12, 2014 Reply by Esmaeil Mottaghi
Extend/Recede Polylines by points Hi Everyone, I am a beginner to Grasshopper, I have been working on a tower. The Floor plates are made using Polylines connected to points.… Started by Jay Smith in Discussion	2	Dec 11, 2014 Reply by Jay Smith