algorithmic modeling for Rhino

Forum Discussions (33,608)

Sort by: View

Discussions	Replies	Latest Activity
Dividing a line with nonuniform distances. I would like to divide a line with points based on the distance of 1 point (Point C) from the start point of the line (Point A). For instan… Started by Aleksandr Kolesnikov in Discussion	5	Jan 7, 2015 Reply by David Rutten
Splitting Surfaces in Grasshopper/Python I have a single surface and a few dozen curves that I want to use to split the surface. I know that there is a srfSplit component in Grassh… Started by jon kontuly in Discussion	11	Jan 7, 2015 Reply by goodriver
Common edge filter Hi, I have problem to collect surface with common edge in the same branch. (I know, using C# I wouldn't have any problem :) ) .... I ha… Started by User in Discussion	4	Jan 7, 2015 Reply by User
Planarize mesh From two rail Surface Hello to everyone! can someone give me a hint of what im doing wrong here? i want to planarize a mesh obtained from a two rail surface... … Started by Esteban Pacheco in Discussion	0	Jan 7, 2015
Offset in 3D Hello All, Could someone help me offset a wire model in 3 dimensions? The goal is to turn it into something that I could then cut out on… Started by Steve in Discussion	2	Jan 7, 2015 Reply by Steve
interpolate curve prob hi guys... i m trying to create a interpolate curve through set of points..but the problem i m facing is every time i have to select an ite… Started by MANU in Discussion	3	Jan 6, 2015 Reply by Michael Pryor
Trim a surface using only polylines fully enclosed Hi! I have this surface with some polylines that are spread over it. I need to select only those that are fully included inside the surfac… Started by Nuno Luis in Discussion	4	Jan 6, 2015 Reply by Pieter Segeren
ANNUAL RADIATION ANALYSIS GREENHOUSE Hi! Actually I want to run an annual radiation analysis in the inside of a greenhouse. CM-sky I suppose is the right one, at least it gives… Started by Daniel Podmirseg in Errors, Bugs and Oversights	4	Jan 6, 2015 Reply by Mostapha Sadeghipour Roudsari
Randomize populate 2d points to extrude pattern Hello All, I have a cube form that is adjustable based on sliders. One of the sliders subdivides the cube into even cells. I have used t… Started by Steve in Discussion	6	Jan 6, 2015 Reply by Steve
Batch convert files? Hi, i have a Problem: i have around 1000 obj files here (all almost the same structure). all of them need to be rotated around 90°. + all… Started by J Frölich in Discussion	25	Jan 6, 2015 Reply by J Frölich