exoskeleton split

Hello guys!

I managed to create a model out of curves using exoskeleton

The problem is that exoskeleton (when it is baked) it creates meshes

I tried to split and trim it using mesh trim, mesh split but it is not working!

Any ideas?

Replies to This Discussion

Permalink Reply by Marios Tsiliakos on June 25, 2013 at 6:00am

Hi Georgios,

The question its self is quite vague, as vague is the number of possible reasons causing this behaviour, thus the solutions available. Please provide a snapshot or the files for a better understanding.

On a side note bear in mind that this is not (98% sure here) an exoskeleton issue. In general when splitting and trimming meshes you will have to ensure that the too meshes are of the same resolution( for example if you split a mesh manipulated with weaverbird smoothened ect ect with a mesh box of 2x2x2 resolution) its doomed to fail..

try to spilt with o mesh box of 300x300x300 res to see what happens.

Hope this helps.

RSS