Grasshopper

algorithmic modeling for Rhino

weave component

hi all,

as u ll see in the attached file, i ve used weave component to create a circular pattern. however, it does not connect the end points of the curves. i couldn't find why it is like that. i would thank if any of u help me,,

Views: 2124

Attachments:

Replies to This Discussion

Permalink Reply by Joaquim Filipe Reis on May 11, 2013 at 9:26am

Just connect "C" input [ Close Polyline ] of PLine to "W" out put of Weave. 

Permalink Reply by Fery on May 11, 2013 at 9:32am

it was so simple :) thx joa ;)

Permalink Reply by Joaquim Filipe Reis on May 11, 2013 at 9:34am

or use toggle connected to "C" of PLine and set to "true"

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service