Grasshopper

algorithmic modeling for Rhino

How to Trim Mesh Surface

Hi guys,

I've been working on this surface from a voronoi study to a delaunay triangulation and this is the following result:

Said so, I need to make this mesh fit in that pink rectangle, but seem really hard or impossible to meshsplit or meshtrim the mesh I created.

Moreover, the same geometry has to be milled. Do you know if possible with meshes (once I would have hopefully been able to trim it...)?

attached is my ghx file if this could be helpful

Thanks

any quick help would be really really appreciated.. finals are coming next week

Views: 13885

Attachments:

Replies to This Discussion

Permalink Reply by lv2311 on April 21, 2013 at 11:17pm

PSPS

i know it might be a problem due to the fact that it's an open mesh..

so any suggestion about how to close would be great!!!!!

Permalink Reply by Andrew Heumann on April 22, 2013 at 10:42am

try extruding your curve and using "Mesh Split"

Attachments:
Permalink Reply by lv2311 on April 22, 2013 at 3:39pm

Hey Andrew,

I actually made it, but had to use "Rebuild Mesh" then "Mesh to Nurb", that before wasn't working. Then I could trim it as I wanted.

Saw just now your reply.

Thanks for your help anyways Andrew!

Lorenzo

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service