Grasshopper

algorithmic modeling for Rhino

Trim lines and bevel geometry

Ι want to trim and then make loft from lines that i  exploded from a surface...in other words I want to make a geometry like this in the jpeg,in every subsurface that I have made.Inside the zip file I have the jpeg ,the gh and the rhino file.any help?

thanks alot!

Views: 1808

Attachments:

Replies to This Discussion

Permalink Reply by Vasilis on April 6, 2013 at 10:29am

just took your definition (3d section 2) and connect my 2 curves in the front.

Permalink Reply by Artyom Maxim on April 6, 2013 at 11:31am

The problem was in the offset component, it required "planes for offset operation" to properly offset the curves.

Attachments:
Permalink Reply by Vasilis on April 6, 2013 at 1:02pm

nothing else to say,exept thanks a lot! :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service