Grasshopper

algorithmic modeling for Rhino

telescoping geometries

I am trying to get a series of concentric extrusions to collapse and expand into each other, like a telescope. However, I would like for them to collapse and expand based on an attractor point. The amount of expansion or collapsing depends on the location of this point. Attached is the gh file. I am quite the beginner.

Views: 314

Attachments:

Replies to This Discussion

Permalink Reply by MARIO VERGARA on February 14, 2013 at 5:07pm

sorry for the delay, i was out of the office

please check out these files

cheers

m

Attachments:
Permalink Reply by hlm on February 14, 2013 at 8:05pm

perfect thank you, very helpful mario!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service