Grasshopper

algorithmic modeling for Rhino

Surface from group of points (Rhino terrain?)

Hi everybody,

I imported a dwg file to rhino that has the altimetry points of the terrain and I would like to create, from this group of points, a surface that simulates the form of the terrain.

I already tried to install rhino terrain (demo trial) but, when I open rhino, it ask me for license that i never heard about her before.

Do you know how I can put rhino terrain to work, or, a way to make this surface?

Thank you for the attention,

Manuel Oliveira 

Views: 2202

Replies to This Discussion

Permalink Reply by Andrew Heumann on October 28, 2012 at 2:50pm

you might start by doing a delaunay mesh of the points with grasshopper. If you need it to be a surface rather than a mesh, you could project a dense grid of points on to the delaunay mesh and then construct a surface from those points. 

Permalink Reply by Manuel Oliveira on October 28, 2012 at 4:15pm

Thank you very much Andrew, it works perfectly :)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service