Grasshopper

algorithmic modeling for Rhino

Sort of offset

I would like to do an offset of a line that follows the motion of 2 parallel curves. Maybe the addition of a distance between points that define the little segment and the X points of the new segment (in green) works ... but I don't know how to do it. Hope that someone could help me.

Views: 995

Attachments:

Replies to This Discussion

Permalink Reply by kleerkoat on October 26, 2012 at 7:35am

dang you are right, it worked in the first file i did, now it's not right, hmm

Permalink Reply by Landscape on October 26, 2012 at 2:08pm

Done!! I found the solution!! Hope this helps somebody!! ;-)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service