Grasshopper

algorithmic modeling for Rhino

need help on waffle

Hi I am try to create a waffle for a brep show below.

the problem is when i get the div line one the surface i try to offset it so that i can loft the two line to the waffle, in ym case some of them works but some of them didnt.. not sure wht is going on. have attach my file pls advice

Views: 1019

Attachments:

Replies to This Discussion

Permalink Reply by Yasser Hafizs on September 8, 2012 at 1:14pm

Hi Ching,

Use solid difference component in intersect tab to cut the joints

example

Permalink Reply by Yasser Hafizs on September 9, 2012 at 5:55am

The problem is in the tree structure, the original lines has 9 branches while the offset lines has 17 branches. You should to equalize the amount of branches in both lines with flatten and graft. 
If you want to discuss more, please reply in the field below, so the others can help too.

RSS

About


McNeel Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2026   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service