Grasshopper

algorithmic modeling for Rhino

sweep 2

I can easily use "sweep 2" command in rhino , but in GH after setting the curves in the sweep2 component it doesn't give me the surface?

Views: 2246

Replies to This Discussion

Permalink Reply by Jesús López on August 10, 2012 at 3:04pm

You need to analyze direction of the rails (in Rhino or Grasshopper)

 

Both rails need to be oriented to the same direction

 

and try to put the cross section at the "beginning" of the rails

I hope this can help you

Jesus Lopez

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service