Grasshopper

algorithmic modeling for Rhino

Trim intersection of an offset surface component

Hi guys,

 

I have offset a surface in both directions from 4 points and lofted into a 3D form, though I am finding that once the surface is offset then there is a clash where two straight lofts meet, is there a way that I can trim at this intersection before joining them? I am currently offsetting the straight components seperately to the central joining component.

 

Thanks

Views: 1203

Attachments:

Replies to This Discussion

Permalink Reply by Kayleigh Dickson on February 28, 2012 at 10:04am

Hi guys,

 

I have attached the Rhino and GH files.

Attachments:
Permalink Reply by Kristian on May 13, 2012 at 7:56pm

Did you have any luck?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service