Grasshopper

algorithmic modeling for Rhino

Merge two grids

I try to merge two grids. I am very new to grasshopper so I tried about every intersect block I could find (without having knowlegde how to use them correctly), so pardon my noobiness.

I managed to get a start with Trim Solid, however this only works if the grids are at the right intersection, normally it's all messed up.

I tried to flatten and graft all I could, but it didn't result in something better.

blocks:

results:

Views: 701

Attachments:

Replies to This Discussion

Permalink Reply by Pieter ter Berg on December 4, 2011 at 12:24pm

It probably ahs something to do that it doesn't know outside from inside after the trim. The offset doesn't go in the right direction, see image:

Permalink Reply by Jissi Choi on December 4, 2011 at 11:46pm

Here is a minor solution.

 

But I think the offset is not a good idea for merging grids..

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service