Grasshopper

algorithmic modeling for Rhino

Problem with creating trees from multiple points

I have a problem with a tree i have created in grasshopper. When i do only one tree it is working fine, but when i try to choose multiple points to start from it all falls apart. One tree is still working but the others get fewer and fewer branches. If i do 3 the third does not get any branches at all. The grasshopper-file is quite large, but it is organised.

 Does anyone know what I have done wrong?

Views: 443

Replies to This Discussion

Permalink Reply by Chris Tietjen on October 19, 2011 at 9:53am

It sounds like you need to graft one of the inputs.

 

Chris

Permalink Reply by hamia Aghaiemeybodi on October 19, 2011 at 2:45pm

you can graft but it depends on your definition wend me your definition and please make it a bit clean and readable ;) . . . 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service