Grasshopper

algorithmic modeling for Rhino

Remove item IF intersecting

Hi, I am trying to make a line based parametric stud wall definition, and im trying to remove the last two studs that are intersecting.  

Currently I have created a IF statement by region intersection and graft.  So when a intersects b, a is culled.  But I think the item I am trying to reference is already culled.  My ultimate goal is to add door/window openings and corner conditions.    

My other question is should this be done upstream or downstream of the solid geometry?

Definition attached, set one curve and adjust length till intersects.

Any help would be greatly appreciated, thanks. 


 

Views: 1433

Attachments:

Replies to This Discussion

Permalink Reply by Dedackelzucht on September 21, 2011 at 12:42am

Hey,

how about this... the repeat component makes it variable. Move the slider.

 

Best Regards

DeDackel

Attachments:
Permalink Reply by tvett on September 21, 2011 at 2:31pm

I see what your doing there, but the last stud needs to be there.

thanks 

Permalink Reply by Dedackelzucht on September 22, 2011 at 1:20am

play around with this!

 

Best Regards

 

DeDackel

Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service