algorithmic modeling for Rhino
orient multiple geometries
hi all
I'm using the orient component and trying to orient a set of multiple geometries at a series of points. problem is, its orienting single pieces of the (multiple pieces of) geometry rather than complete copies. I'm sure I'm not explaining this well...
in the image under the #3 is the near complete set, then by #1, is just a part of it....
thanks a lot
I'm using the orient component and trying to orient a set of multiple geometries at a series of points. problem is, its orienting single pieces of the (multiple pieces of) geometry rather than complete copies. I'm sure I'm not explaining this well...
in the image under the #3 is the near complete set, then by #1, is just a part of it....
thanks a lot
Views: 644
- Attachments:
-
-
Picture 1.png, 38 KB
-
Replies to This Discussion
-
Permalink Reply by Daniel Piker on
-
Maybe try switching from Longest list to Cross reference ? (when you right click the Orient component)
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
© 2024 Created by Scott Davidson.
Powered by
