algorithmic modeling for Rhino
Delaunay mesh boundary
Hi:
In the example below is there any way to cause the Delaunay function to produce the mesh on the right rather than the one on the left? I edited the rightmost mesh by hand to delete the mesh faces outside the outer boundary.
Al
Views: 1651
- Attachments:
-
-
delaunay test.ghx, 44 KB -
delaunay test.3dm, 92 KB
-
Replies to This Discussion
-
Permalink Reply by Danny Boyes on
-
Hi Al,
You need to come up with a routine for culling the faces that you don't want.
The following method compares all the vertices of a face for Z = 0 and then culls the inverted pattern.
- Attachments:
-
-
delaunaytest2.ghx, 207 KB
-
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Bridge Tower
Added by Parametric House 0 Comments 0 Likes
-
Contour Table
Added by Parametric House 0 Comments 0 Likes
© 2025 Created by Scott Davidson.
Powered by
