Grasshopper

algorithmic modeling for Rhino

Offset Curve bug

Hello,

 

I'm using the latest version of grasshopper (0.8.0010). I've read about the problems of offset curve and I'd like to share this with everyone to see if there are any suggestions to fix it. The short yellow curves are the ones that don't offset properly. Thank you very much in advance.

 

Yagiz

Views: 597

Attachments:

Replies to This Discussion

Permalink Reply by kleerkoat on May 25, 2011 at 10:40am
have you tried moving the crv start point or seam?
Permalink Reply by akif yagiz saraclar on May 26, 2011 at 12:18am

A slight change fixes it. thanks for the advice.:) there is still a bug though.

Cheers,

Yagiz

Permalink Reply by akif yagiz saraclar on May 26, 2011 at 12:25am
When I make a slight change, it fixes the problem at that particular curve but creates another one at a different curve (which are sections of a surface). Well of course I fixed it by playing around with the whole thing for a while.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service