Grasshopper

algorithmic modeling for Rhino

Rhino Gumball

Hi, i realize that this probably belongs in a rhino forum as opposed to a grasshopper forum but i assume there should be some cross pollination here.

 

i just started using the gumball in R5 and am trying to figure out if i can set a hotkey for the "relocate gumball" command (i dont know its marco). im getting a little tired of having to click on the gumball, click on relocate gumball, and then set the position i want everytime i need to change it.

 

thanks in advance

Views: 488

Replies to This Discussion

Permalink Reply by Danny Boyes on May 18, 2011 at 10:26am
You should also post your question here if you don't get any answers.
Permalink Reply by Mario L on May 18, 2011 at 10:37am
thanks Danny, i didnt know about that page.
Permalink Reply by kleerkoat on May 18, 2011 at 11:15am
not at the moment, as far as I know.  it's been requested.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service