algorithmic modeling for Rhino
dividing curves and offsets
i am trying to get equal divisions on a curve (a set of curves) and its offset (their offsets)
in example 1 this works fine, i use a slider to control the number of divisions.
in example 2 (which is what i am after) i control the number of divisions by a lenght-component and divide its output by a number (5). using this final output-list to divide the original curves works as expected, but if i connect the same output to the N parameter of the offset curves, the division component creates additional divisions to the desired ones.
thanks in advance roberto
in example 1 this works fine, i use a slider to control the number of divisions.
in example 2 (which is what i am after) i control the number of divisions by a lenght-component and divide its output by a number (5). using this final output-list to divide the original curves works as expected, but if i connect the same output to the N parameter of the offset curves, the division component creates additional divisions to the desired ones.
thanks in advance roberto
Views: 687
Replies to This Discussion
-
Permalink Reply by Lars Renklint on
-
That would be because your original curves are all on one path. But the offset puts the 4 resulting curves on separate paths.
Right-click the C input of the first divide-component and flatten. -
-
Permalink Reply by roberto gagliano on
-
thanks a lot!
i´ll try to find what one path and flatten means
cheers roberto -
-
-
Check the tutorials page and download Andys GH primer.
On page 36 and forward you can read about this (flatten is explained on page 39) -
-
-
thanks again!
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Recrusive Split
Added by Parametric House 0 Comments 0 Likes
-
Table Field
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
