algorithmic modeling for Rhino
Surface Panelling...
Hi,
I've been getting to grips with GH over the last couple of days, and not doing too badly... so i thought.
Could anybody help point out where i've gone wrong with the attached definition please?
It's intended to be a lofted surface comprised of a series of 4-sided panels. There is one definition for the shape of the surface, and another for the panel detail.
The problem arises when i try to combine both definitions to get the panels to take the form of the lofted surface. Rhino just freezes. My file should explain more...
I've tried LOADS of alternatives, but as yet been unsuccessful.
Any tips/advice/help is very much appreciated,
Thanks in advance,
David.
I've been getting to grips with GH over the last couple of days, and not doing too badly... so i thought.
Could anybody help point out where i've gone wrong with the attached definition please?
It's intended to be a lofted surface comprised of a series of 4-sided panels. There is one definition for the shape of the surface, and another for the panel detail.
The problem arises when i try to combine both definitions to get the panels to take the form of the lofted surface. Rhino just freezes. My file should explain more...
I've tried LOADS of alternatives, but as yet been unsuccessful.
Any tips/advice/help is very much appreciated,
Thanks in advance,
David.
Views: 1490
- Attachments:
-
-
GH ROOF GRID TEST.3dm, 174 KB -
GH ROOF GRID TEST.ghx, 169 KB
-
Replies to This Discussion
-
Permalink Reply by dcay on
-
hi,
maybe this helps... u still have to figure out how to do a offset of the polyline... - Attachments:
-
-
paneling.ghx, 115 KB
-
-
-
Permalink Reply by Stuart Fingerhut on
-
cool, thanks for sharing.
-
-
Permalink Reply by David Wood on
-
Thanks a lot for your help dcay.
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
© 2024 Created by Scott Davidson.
Powered by
