Grasshopper

algorithmic modeling for Rhino

Taper

hello all,

I am want to taper a cuboid, but only on the top face. i could find lot of help and suggestions in this blog and I couldnt find a solution for my problem. I have attached a Right view of the cuboid. Hope you guys can help me. 

Thanks,

Aravind

Views: 564

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on June 15, 2017 at 9:06am

Hi.

You can try "Taper" in GH R6 WIP, but if you want to tilt the topmost face only, then "Twist Box" is one of easiest way to do this.

Attachments:
Permalink Reply by Aravind Kumar Jayasankar on June 16, 2017 at 5:45am

Thank you so much it works

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service