Grasshopper

algorithmic modeling for Rhino

double grid shell

so i've manged to offset the curves to the offsetted surface. then geodesic curves work but also adds extra curves which don't match the original offset??

also Ive being trying to add a pin/rod which runs between the 2 geometry, so i can then create a hole for the pin to go through? 

i can get a pipe though the intersecting points, but it doesn't work on all of the intersections,

please help someone 

Views: 433

Attachments:

Replies to This Discussion

Permalink Reply by Ayk Martirosyan on May 14, 2017 at 9:18pm
You GH file doesn't contain Input curves, internalise them and upload again
Permalink Reply by Leonie on May 14, 2017 at 9:52pm

i just internalised all the geometry, don't have a lot of practice with internalising data, so i hope it works 

Attachments:
Permalink Reply by Leonie on May 14, 2017 at 9:54pm

and here is the rhino file 

Attachments:
Permalink Reply by Ayk Martirosyan on May 14, 2017 at 11:17pm

Why do you want to offset the curves? I don't get it. Is that what you want to achieve?

Permalink Reply by Leonie on May 15, 2017 at 2:41am

we basically want retractable lattice, in a cylindrical/mushroom shape. 

so it can be packed away easily

 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service