Grasshopper

algorithmic modeling for Rhino

cylinder crossgrid

Hello.

I'd like to make a cylinder divided by a diagonal grid.

However, the joint of the divided surfaces does not work.

Perhaps, it may be that the method you are trying does not fundamentally go wrong.

（I am using a lunch box.）

Excuse me, but could anyone tell me?

Views: 344

Attachments:

Replies to This Discussion

Permalink Reply by Hiroaki Takahashi on February 11, 2017 at 10:02pm

Sorry,I forgot to paste the image.

Attachments:
Permalink Reply by Hyungsoo Kim on February 12, 2017 at 12:40am

Hi.

It's a bit more complicated than I thought, anyway check this out. Best.

Attachments:
Permalink Reply by Hiroaki Takahashi on February 12, 2017 at 1:15am

Thank you for always telling me!

Wow,,,

This composition is very beautiful, but it has lots of new knowledge for me.
I will do my best to master it!
Thank you very very much ^^

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service