Grasshopper

algorithmic modeling for Rhino

Cannot loft a list of lists with two curves in it. Can someone please help me with it?

Hi,

I'm trying to create a wall of louvers. I ended up with a list of lists with two curves in each list. I tried to loft the lists of curves, but it is not lofting the curves and I can't figure out why it can't.

Thanks in advance  

Views: 343

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on November 17, 2016 at 5:52am

Like this?

Attachments:
Permalink Reply by Ranj on November 17, 2016 at 6:30am

Finally... Thank you very much for your help. I forgot to use the original poly lines as the start of the lofts and the manipulated ones as the second curve.

Attachments:
Permalink Reply by Ranj on November 17, 2016 at 6:07am
Thanks for your reply, but the it should be open at the places where it is pulled out. Similar to: http://www.torabiarchitect.com/blog/?p=45

I think I have made a mistake earlier on

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service