Grasshopper

algorithmic modeling for Rhino

hello i am a beginner in karamba .and i want to analyze displacement of some point on a diagrid structure in a tall building if it is exposed to wind load.these points are in floor levels of building.i have tried a point load component for each of these load cases but it shows that all of the displacements are zero or sometimes it shows the error of stiffness matrix

Views: 451

Attachments:

Replies to This Discussion

I think you have to flatten instead of graft the Load-input of the assemble component.

if i flatten it shows me one displacement for all of the structure.i want to have displacement for each load cas

if i flatten  it shows me one displacement for all of the structure.i want to have displacement for each load case

Set the load-case of your loads via the 'LCase'-input-plug at the load-components. Then select the load-case to display via the ModelView-component (sub-menu at the bottom: 'Load-case Selection'). For further details please read the Karamba manual.

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service