Grasshopper

algorithmic modeling for Rhino

Trimming offset curves to create blocks

So I have a network of curves that I am using as a grid system and I have offset them to create the streets now I want to take the curves and trim them so there are no overlaps and then join the remaining curves so that it forms lots. 

Here is an example of what I want that I did manually in Rhino.

And here are pictures of what I have so far.

Also I am sure I connected the curves in a super inefficient way so any advice on that would be greatly appreciated. I did it connecting points with the polyline component because the Delaunay Edges component was giving me some curves that I did not want.

Thanks! 

Views: 1206

Attachments:

Replies to This Discussion

Permalink Reply by Ryan Zeringue on June 23, 2016 at 7:49pm

I've gotten it this good but it doest work well when only two curves connect.

Permalink Reply by mark zirinsky on June 23, 2016 at 7:56pm

you can draw a line between outside vertices, then use the offset-loose" component

Permalink Reply by Hyungsoo Kim on June 24, 2016 at 1:29am

Hi.

Here is another approach.

Attachments:
Permalink Reply by Ryan Zeringue on June 24, 2016 at 3:17am

Thanks Hyungsoo!

Permalink Reply by Ryan Zeringue on June 25, 2016 at 3:05am

Hyungsoo, if i try to connect the points with a Delauney Edges component instead of with polyline this method doesnt work. Do you know why that it?

Permalink Reply by Hyungsoo Kim on June 25, 2016 at 5:09am

If you have used  "Delaunay Edges", there would be no chance to succeed because they are not "polylines".

Instead, try to use "Delaunay Mesh". Best.

Attachments:
Permalink Reply by Ryan Zeringue on June 25, 2016 at 5:34am

Amazing! Thanks so much!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service