Why i cannot use brep join feature to join two surfaces together? file attatched

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on June 1, 2016 at 3:18am

Hi.

Is there any reason you shouldn't use Bi-Arc output curve for your loft?

Permalink Reply by Tian on June 1, 2016 at 5:31am

in the tutorial it said use both will cause unexpected isocurve on the surface, it is better to do it separately then join, But i can not.

Permalink Reply by Hyungsoo Kim on June 1, 2016 at 5:58am

Whatever the tutorial said, I feel like dismiss about it.

As you can see, If you mach two surface's edges using "sweep 2", you can get joined open brep.

Nevertheless, I'd rather use "Bi-Arc"output because it can produce "Untrimed Surface". 

Attachments:

• join_re.gh, 15 KB

Permalink Reply by Tian on June 1, 2016 at 7:15pm

Thank you, its better to use both, by the way now sweep 2 rail is really efficient of this than loft half half.! Thank u again